Your shopping cart is empty!
Some heat pumps can consume between 40 and 60 Amps worth of power; therefore, it may be necessary to have a higher amperage breaker base to accommodate heat pumps. Combine the features of the PE653RC Multi-Wave Control System with the convenience of the PE30000 80 Amp Intermatic Panel and create a powerful PE30065RC wireless control system kit for any pool or spa installation. The PE30000 Series Panel includes an eight position 80 Amp breaker base to accommodate a variety of different equipment loads and two mechanism slots to accommodate the vast array of mechanisms Intermatic has to offer. In addition, there is a low voltage raceway for low voltage control lines (i.e. actuators, sensors, etc…), four décor knockouts for GFCIs and switches, and a convenient side knockout for an outdoor receptacle.
Enclosure & Control: NEMA 3R rated for Indoor/Outdoor installations 0.048 in. steel with light beige finish 22 in. (55.9 cm) H x 14 3⁄4 in. (37.5 cm) W x 4 1⁄4 in. (10.8 cm) D
Knockouts: Two 1.09 in. diameter through holes, six combination 1⁄2 – 3⁄4 in.
knockouts, 2 combination 3⁄4, 1, 1 1⁄4 in. knockouts, four 1⁄2 in. knockouts on the bottom. Two combination 1⁄2 – 3⁄4 in. knockouts on the left side and four combination 1⁄2 – 3⁄4 in. knockouts, two combination 3⁄4 – 1 in. on the back. One knockout 1 3⁄4 x 2 3⁄4 in. on the right side for mounting switches or GFCI.
Panel Rating: 80 Amp 120, 240 VAC or 120, 208 VAC single phase
Ratings: Control Supply: 120, 240 VAC, 50/60 Hz, 5-Watts Maximum Circuit #1: 20 Amp Resistive (17 FLA, 80 LRA) 120, 240 VAC 50/60 Hz Circuits #2 thru #5: 15 Amp Resistive (10 FLA, 60 LRA) 120, 240 VAC 50/60 Hz
Included in Kits: • Multi-Wave Control System (PE653RC) • Owner’s Manual • Three AA Batteries • Small Flat Head Screwdriver • Equipment Labels • Hand Held (PE953) Transmitter • Water Sensor (PA122) with Hose Clamp • PE30000 Enclosure w/80 Amp Base • P4043ME Actuator Controller (PE34065RC only) • (2) PE24VA Water Valve Actuators (PE34065RC only)