RAYPAK E3T Spa Heater 5.5 KW 240v Single Phase

Built-in intelligence.

The E3T is equipped with easy to use digital controls and diagnostics. Our digital control center shows the desired set point and lets you set the temperature exactly where you want it. The easy to read display allows you to see temperature, GPM flow, and diagnostics. The intuitive alert system keeps you informed.

           Main Display                                  Flow                                  Diagnostics
             

Main Features: 
 

Titanium Element

The E3T has a robust titanium heating element that not only prolongs the life of the heater, but allows it to work in extreme pool water environments, such as salt water chlorinated pools.

316L Stainless Steel

316L stainless steel is used in the construction of our heaters. This high grade, corrosion resistant steel is especially suited for salt water heating applications.

Flow Sensor Technology
E3T operates by utilizing the latest flow sensor technology instead of the traditional pressure switch activation. Our heater is programmed to have a minimum flow activation rate of 15 Gallons Per Minute, this helps protect the elements and prolong their lifespan.

Solid State Design
The E3T uses solid state controls to eliminate noisy and troublesome contactors providing quiet, reliable operation. The advanced design allows the heater to modulate power, only using the energy necessary to maintain desired temperature.

Ready To Install
E3T pool and spa heaters are compact, come standard with union connections, and are easy to install. They are the perfect solution for a new pool or spa, as well as to replace any existing pool or spa heater. Available in 5.5, 11, 18 and 27 kW.

New Model Upgrades:

• External manual reset button
  • In the event that a manual reset is needed, it can be done without opening the cabinet.
• More fault code identifiers
  • Now with 10 unique fault codes (up from 5) for enhanced operational data and troubleshooting.
• Low temp/freeze protection modes
  • If the inlet temp is lower than 36F (2.2C) with sufficient flow rate, the heater will operate at reduced heating capacity to prevent water freezing inside the unit and return for normal operation once the inlet temp reach 40F (4.5C) and meets the minimum flow rate.
  • If the Inlet temp is less than 32F (0 C) the unit will shutdown to prevent damage and the control buttons will not function.
• Element failure protection
  • In the rare event that any of the heating elements experience a failure, the unit can continue to operate safely at reduced capacity until the element can be replaced
    • ELS0027 model only.

   
                 Union Connections





DIMENSIONS: